Most of Henke’s truck plows can be adapted for use with your Loader or Grader, just add an adapter and you’re ready to go!

Straight Moldboard, no tapering at discharge end
Straight/traditional moldboards are used for a wide variety of applications and in a wide variety of plowing environments:
- High Speed and/or Slow/Low Speed
- DOT
- County and/or Rural and/or City/Urban
- Airport

Expressway Moldboard, Tapering Toward Discharge End(s) from Center
Expressway moldboards typically have a “bow tie” (or partial “bow tie”) shape to them; they’re typically – but not always – higher on the discharge ends than in the middle. Some common End-Middle-End moldboard heights are:
- 40-40-58
- 58-40-58
- 53-46-53
- 36-36-54 – Tube Table, Torsion Trip Edge Only
- 54-36-54 – Tube Table, Torsion Trip Edge Only
- 66-41-66 – Tube Table, Slotted Trip Edge Only
Expressway moldboards are used for a wide variety of applications and in a wide variety of plowing environments:
- High Speed and/or Slow/Low Speed
- DOT
- County and/or Rural and/or City/Urban
- Airport

Funnel/"One Way" moldboards are designed for throwing snow as far as possible from the roadway
Henke funnel shaped plows come in several sizes, and are somewhat funnel shaped in that the intake/driver’s side of the plow is shorter than the discharge/curb side of the plow. The following intake/discharge heights are the most common:
- 30-47
- 30-60
- 39-52
- 40-65
Funnel moldboards are used for a wide variety of applications and in a wide variety of plowing environments:
- High Speed and/or Slow/Low Speed
- DOT
- County and/or Rural
- Airport

Adapts a Truck Plow to a Loader or Grader Lift Group
We provide multiple styles of coupler adapters to fit your machine and your equipment mounting requirements.
Use this adapter to fit most truck plows to your loader or grader further increasing your snow fighting abilities!
